Line cut
In the continuous extrusion manufacturing method, the quantity of product is inevitably large, as the higher quantity is often advantageous.
We reduce losses by performing inline cutting, which aims to reduce end material loss and time in the secondary process of cutting.
This was made possible by our accumulation of contraction data and the our original machinery and equipment.
Specialized production line for long and wide product extrusion
Extrusion production line of our original long and wide products.
This is a large equipment that differs from smaller products such as pipes.
At the end of the production line, there is a roll-up equipment, where products are rolled up while being measured for length.
Continuous cutting of short products
We perform continuous cutting while extruding continuously.
Some of the products are as small as 20L, these products are also cut continuously in-line to eliminate the next process.
Progressive feed punching equipment
Equipment for performing feed-cutting processing after winding up a long product.
This is a production method that aims to continuously punch out products, rather than reducing costs by increasing the number of holes or reducing the number of shots.
Line printing
Marking processing of products in continuous extrusion. In-line line printing is performed and set with product cutting. Indelible ink is used for ink.
In-line taping process
Processing to apply tape while continuously extruding products.
Since primer coating is performed in the in-line process while laminating, high productivity and low cost can be achieved.